CZ TS 2 [base model] red dot mounts

[base model] red dot mounts for the CZ TS 2.

Collections

  • Collection

  • Collection

  • Collection

  • Collection

  • Collection

  • Collection

  • Collection

  • Collection

  • Collection

  • Collection

  • Collection

  • Collection

  • Collection

  • Collection

  • Collection

  • Collection
CZ Shadow 2, CZ TS 2, CZ 75B, SP-01, P-01 & Compact front sight filler

CZ TS 2 [base model] red dot mounts

(1 products)

CZ TS 2 [base model] red dot mounts replace the rear sight in the dovetail so you can mount an optic on a non-Optics Ready TS 2—no milling and fully reversible.

Why choose a dovetail mount?

  • No permanent mods: run a red dot without altering your base TS 2 slide.
  • Test before committing: try optic models/positions, then swap back to irons in minutes.
  • Clean setup: model-specific fit designed to stay tight through training and matches.

Commonly supported footprints

  • Trijicon RMR footprint
  • Shield RMSc footprint
  • Holosun K-series footprint
  • Leupold DPP footprint
  • C-More RTS footprint
  • Vortex Venom / Docter footprint
  • Aimpoint ACRO footprint

Install basics

  • Degrease interfaces and screws; apply Loctite threadlocker.
  • Torque to spec for mount-to-slide and optic-to-mount screws; recheck after your first range session.
  • Verify screw length & pitch so nothing protrudes into the slide channel.

Running an Optics Ready TS 2?

For OR slides, a plate provides a lower, more rigid interface—see Optics Ready plates.