This collection covers the CZ Shadow 2 parts that do not fit any other category: magazine release buttons, disconnectors, guide rods, a magazine kit and a sight tool. Most of them let you fit the pistol to your hand or tune the trigger and the cycling for competition. You can choose parts from Eemann Tech, Zendl, CZ, Lok, Toni System and Armanov.
Magazine release buttons
-
Zendl adjustable mag release: 5 positions of the button, in three sizes: 19 mm for smaller hands, 17 mm for normal hands and 15 mm for larger hands. Zendl also makes the AZ button for the Shadow 2 alone.
-
CZ adjustable mag release button: 3 positions, aluminium. A spare CZ screw is available if you lose or damage the original.
-
Lok oversized Gridlok button: 3 positions, aluminium and brass.
Disconnectors
Eemann Tech makes four disconnectors for the Shadow 2 and SP-01 Shadow. They change how the trigger feels and how much pre-travel it has:
-
Competition disconnector: for more consistent trigger feel, used in IPSC and USPSA Production setups.
-
Brass Competition disconnector: brass gives lower friction than steel, for a smoother trigger.
-
Custom Zero disconnector: lets you adjust single action pre-travel, close to zero depending on the setup. It needs precise fitting.
-
Ultimate ET disconnector: reduces pre-travel and works with older and newer trigger bars.
Have a qualified gunsmith install a disconnector.
Guide rods
-
Toni System spring guide rod: adds mass under the barrel to reduce muzzle flip. You can choose brass, steel or ergal.
-
Eemann Tech stainless steel guide rod: AiSi 316 stainless steel, 20 g, a direct replacement of the factory rod. It is legal for IPSC Production.
Magazine kit and tool
The Eemann Tech kit with a thin competition follower and an extended spring is made for Mec-Gar CZ 18 round magazines. You fit it without tools. The Armanov rear sight pusher moves the rear sight to the side without a hammer and vise.
For the Compact, see CZ Shadow 2 Compact other accessories. For all Shadow 2 parts, see CZ Shadow 2 accessories.
Frequently asked questions
Can I install a disconnector at home?
No. Eemann Tech recommends installation by a qualified gunsmith, and the Custom Zero disconnector needs precise fitting.
Is the Eemann Tech stainless guide rod legal for IPSC Production?
Yes. It is legal for the IPSC Production division.
Which mag release button size do I need?
On the Zendl button, 19 mm suits smaller hands, 17 mm normal hands and 15 mm larger hands.
Sold out
